I have acquired couple MTC3600s and would like to replace an old 6809 I have running. While I know the 6809 inside and out and can configure them however needed, I cant say the same for the MTC. I have most of the manuals for these controllers and get what is required to set them up. I made a call to moto/sys support to get the process started for a new codeplug and all, since I didn't get anything but the manuals I then asked what I had to do about getting the BETS and/or Firmware/application software and was pretty much told to contact sales for a new p25 system . Does anyone know of maybe a kit part number for the required software to do the configuration and code plug load on these, that way I can maybe call and try to order it that way? They gladly will generate a new codeplug but seem not interested in helping with the rest. I do not understand why they have gotten so difficult for stuff these days.
1 post • Page 1 of 1